PeptideWiki

LL-37 and TFA: what the trifluoroacetate figure on a peptide COA means

Published by the PeptideWiki editorial team.

LL-37

TFA salts of synthetic peptides can be 18–35% trifluoroacetate by weight. Why strongly basic LL-37 carries a heavy counter-ion load, and how labs measure it.

A TFA figure on a certificate of analysis (COA) tells you how much of the vial's weight is trifluoroacetate, not peptide. In the TFA salts measured in the studies cited below, that share ran from roughly 18% to 35% of the powder. For a strongly basic peptide such as LL-37, the figure is worth reading closely.

Where the TFA comes from

Trifluoroacetic acid is used twice in standard Fmoc solid-phase synthesis. It cleaves the finished chain from the resin and strips side-chain protecting groups. It is then used again as an ion-pairing agent during reversed-phase HPLC purification.

The negatively charged trifluoroacetate ion pairs with positive sites on the peptide. Those sites are the free N-terminus and the side chains of arginine, lysine and histidine. After freeze-drying, the peptide is isolated as a TFA salt. The synthesis guide covers the chemistry in more detail.

A 2025 paper in Pharmaceuticals by Erckes and colleagues measured TFA in four angiotensin-derived peptides after purification. TFA reached up to 35% of total weight. Stoichiometric pairing with the positive charges would have predicted about 25%. The authors concluded that synthetic peptides "seem to contain excess TFA beyond the expected numbers corresponding to charge."

An older Dionex application note (AN115, 2002) found 184 to 202 mg of TFA per gram in three peptide TFA salts. That is about 18% to 20% by weight. Two peptides supplied as acetate salts had less than 0.3 mg/g.

Why LL-37 carries a heavy counter-ion load

LL-37 is a 37-residue cathelicidin peptide. Its sequence, LLGDFFRKSKEKIGKEFKRIVQRIKDFLRNLVPRTES, contains six lysines and five arginines and no histidine. A published sequence table lists its net charge as +6.

That gives 12 potential cationic sites, counting the N-terminus. Using standard residue masses, the free peptide weighs about 4,493 Da. If each of those 12 sites carried one trifluoroacetate ion, TFA would be about 23% of the salt's weight. This is our own calculation from the sequence, not a measured value.

The Erckes data suggest real batches can run higher than a simple charge count predicts. The point is not the exact number. It is that a highly basic peptide will carry far more counter-ion mass than a short, neutral one. You can check the charge profile of any sequence with the sequence analyzer.

How labs measure it

Counter-ions are measured with methods separate from the purity assay. The main options from the sources cited here are compared below.

MethodWhat it reportsPublished performance
Ion chromatography, suppressed conductivityTFA, acetate, fluoride and other anionsTFA detection limit 300–600 ng/mL; 91–106% recovery from peptide matrices (Dionex AN115)
HPLC with evaporative light-scattering detectionTFA, chloride and sodium in one runQuantification limit 5.8 µg per mg of peptide salt (Erckes 2025)
19F NMRFluorine signal from TFA onlyQuantification limit 10.3 µg per mg; RSD under 3% (Erckes 2025)
FT-IRC–F stretch near 1200 cm−1Quantification limit 178 µg per mg; judged suited to qualitative confirmation (Erckes 2025)

Shimadzu publishes an ion chromatography application for TFA and chloride in synthetic peptides. It notes plainly that "the weight of the lyophilized peptide includes the weight of this TFA."

Reading the number on a COA

Because TFA adds to the weighed mass, a TFA figure is one reason net peptide content is lower than the mass in the vial. Other counter-ions, such as acetate or chloride, add to that mass too. Our guide to purity versus net peptide content explains how these figures relate.

A few checks help when reviewing a document:

  • Salt form stated. Erckes and colleagues recommend that the salt form be reported explicitly in peptide studies. A COA that names "TFA salt" or "acetate salt" is more informative than one that does not.
  • Method named. A TFA value should come with its method, such as ion chromatography or 19F NMR.
  • Consistency with the sequence. A TFA salt of a basic peptide like LL-37 reporting near-zero TFA, with no exchange step described, deserves a question.
  • Purity kept separate. HPLC purity and TFA content are different measurements. One does not stand in for the other.

The COA checker and the COA reading guide walk through the other fields.

Why researchers care, and the exchange options

Counter-ions can change results in vitro. A GenScript technical review summarizes work by Cornish and colleagues in fetal rat osteoblast cultures. TFA reduced cell numbers from 10 nM, while hydrochloric acid did not have the same effect.

The same review cites Sikora and colleagues on antimicrobial peptides, including LL-37. Salt form changed cytotoxicity and hemolysis results. For pexiganan, the acetate form gave 30.75% hemolysis at 256 µg/mL, against 7.04% for the TFA form. No single salt was best on every measure.

Erckes and colleagues also tested membrane permeation in liposomes. For the cell-penetrating peptide pVEC, the TFA salt permeated and the chloride salt did not. For penetratin, passive uptake appeared unaffected by the counter-ion. Their summary: "counterions are not passive components."

Exchange is possible after synthesis. In the 2025 study, one freeze-drying cycle from 10 mM hydrochloric acid brought TFA below 1% by weight. Purity stayed above 96% throughout. The authors note that efficiency may depend on sequence, so they advise re-testing TFA and purity after exchange. Acetate exchange was not tested in that work. The trade-offs are covered in our TFA versus acetate guide.

All of this evidence comes from analytical work, cell cultures and model membranes. It describes how counter-ions affect measurements, not effects in people.

Sources

  1. Pharmaceuticals (MDPI): Erckes et al., Towards a Consensus for the Analysis and Exchange of TFA as a Counterion in Synthetic Peptides and Its Influence on Membrane Permeation (5 Aug 2025)
  2. Dionex (Thermo Fisher): Application Note 115, Determination of Trifluoroacetic Acid (TFA) in Peptides (2002)
  3. Shimadzu: Determination of Counter Ions of Synthetic Peptides Using Ion Chromatograph (13 Feb 2025)
  4. GenScript: Impact of Counter-ion in Peptide on Studies in Different Research Fields (technical review, undated)
  5. BMC Microbiology: Natural and synthetic cathelicidin peptides with anti-microbial and anti-biofilm activity against Staphylococcus aureus, Table 1 (2011)

Educational content only, not medical advice. Compounds discussed as research materials are for laboratory research use only and are not for human or veterinary use.

More from the blog